Hi Guys. Here are some examples of my work going from when I first started out to the most recent examples. They are made of D2 steel. I am a low tech maker. I have a hard wheel bench grinder and drill press and have only recently added a belt and disk sander. All the rest is done by hand with hacksaw, coping saw and files and sand paper.

  

These first 3 are made from 4.5 mm thick steel. The Bottom one has a mortise tang. The blades on these ones are 120 mm long or there abouts. The handle material on the top and bottom ones is Green Canvas Micarta.

 

The top 2 of these 3 are 4.5mm thick the bottom one is 4 mm. Both brown handled ones are mortice tangs. The top one is my attempt at a Fallkniven S1. The bottom 2 have blades about 4.5 in long. The handle material on the top and bottom ones is Brown Canvas Micarta. The middle one has Green, black and pistachio G10 with flared tube rivets.

 

 

Of these last 3 the top 2 are 4 mm thick, the bottom one is 4.5mm thick and has a mortise tang. The top knife you may have already seen in my first post. The Middle knife has a 4.25 in blade and has black and red Linen Micarta handle the bottom knife is Black Canvas Micarta.

 

I'd eventually like to get my designs and finishing good enough to sell to cover my costs.

 

I'd appreciate any feedback that you all may have on them and I am more than happy to answer any questions that you may have too.

Thanks Kevin.  

Views: 1186

Reply to This

Replies to This Discussion

Hi Lachlan - No at the moment I don't do sheaths for them
I'm interested in buying one too, the very top one. How much would that cost?
How much would it be for the 2nd to last one
Hi Lachlan $65 plus postage
Hi Gregory $70 plus postage
Sweet, I'll check what's on offer when I go to Armistace in Cambridge, if there aren't any really good deals there, I'll probably get this.

Where do you get you Micarta from mate?

I get it from the states. Google Sheffield knifemakers supply 

Here is my stash of knives, I made all of them. I am all for functionality versus cosmetics.

My knives are made from CPM 3V, CPM M4, O1 , L6. I do favour my CPM M4 in 62Rc, This steel holds an awesome edge and relatively tough.

I could not upload the pics earlier I think I have managed this now. thanks

RSS

Support Us

Shop through this affiliate link portal as we get a small commission:

www.fishpond.co.nz

Videos

  • Add Videos
  • View All

Photos

  • Add Photos
  • View All

© 2018   Created by Ryan Johnson-Hunt.   Powered by

Badges  |  Report an Issue  |  Terms of Service